#Rubber old bowling balls for sale pro#

The ball has warmed up some, so it won’t draw the heat out as fast, thus the water stays warmer longer. I rub that around to cover the whole ball and reheat the water in the bucket back up to 130°(120° for sensitive balls) keeping in mind that the water won’t cool down as fast now. I take the ball out, and set it in the sink, and spray with simple green/water 50% solution. Depending on the temp you are using(125°-140°) and it should have cooled down to about 120☏ or lower.

Then I put the ball in the first time for five to ten minutes, check the thermometer. I give 2 squirts of Dawn Foam(It MUST be Dawn FOAM) to the water, and mix it in or add it before I dump the heated water in. I have used a 120° water temperature on sensitive balls, and reheated the water when the temperature fell to 115° or below. Or invest in a Bowling Ball Rejuvenator and clean your ball the easy way! Check it out.ġ20° Maximum for Sensitive Bowling Ball Cleaning They will clean your ball for a small fee.

#Rubber old bowling balls for sale pro#

If you do not want any changes to the color, then simply do not use the hot water bath, and clean the ball however you normally do, or take it to the pro shop in your local bowling alley. Most will return to normal appearance after a few games and some oil is picked back up. Normally this does not affect the ball in any adverse way, but they do change in appearance and look funny. If you see any changes, and do not like this, stop and remove the ball. Some balls will discolor in the water bath, so to check a ball for the first time only place the ball in the water for about 5 minutes, and remove and inspect it.ĭo this for every 5 minutes or less the first time. The ball will quickly drop the temperature 5 or more degrees in a few minutes as the ball warms up.

( Caution: If your ball manufacturer has a temperature limit of say 125° then Do Not Exceed that…keep temperature at or below it). When I dump the heated 140° water in and mix, it settles out about 130º. Heating the remaining hot tap water to the correct temperature only takes a few minutes.ĭepending how much water is needed in the bucket to cover the ball, (usually, about 1 inch of hot tap water is left in the bucket) at about 115º F. I also use hot tap water, so the small amount left in the bucket is pre-heated. The pot I use to heat the water on the stove is smaller than the bucket and so a small amount of water is left in the bucket after I fill the pot. When Bowling Ball Cleaning Be Very Careful With Water Temperature I like to get the temperature of the water heated to around 140° F on the stove. Use a candy thermometer, just because it has high enough temperature readings on it.

It is the hot water sweating the oil out that deep cleans the ball. I check to make sure I have enough water to cover the ball to start, then heat my water. I generally like to use the dawn dish-washing foam,(It just works better than regular dawn!) and add a little ammonia(optional) say 1/4 cup in the bucket and put the ball right in hot water for ten minutes. To get more hook out of the ball, it is important to deep clean the ball. 7 My Own Bowling Ball Cleaning Solution Deep Bowling Ball Cleaningĭeep Cleaning your bowling ball is one of the best bowling ball cleaning tips I can offer any bowler.